Interstate 26 in North Carolina

This article is about the section of Interstate 26 in North Carolina. For the entire route, see Interstate 26.

Interstate 26
I-26 highlighted in red and Future I-26 highlighted in blue
Route information
Maintained by NCDOT
Length	52.69 mi (84.80 km)
Existed	1966–present
Tourist routes	I-26 Scenic Highway
NHS	Entire route
Major junctions
West end	I-26 / US 23 at the Tennessee line near Faust
Major intersections	US 19 / US 23A near Mars Hill (unfinished segment) I-40 / I-240 / US 74 in Asheville US 25 / US 25 Bus. in Fletcher US 64 in Hendersonville US 25 near East Flat Rock US 74 in Columbus
East end	I-26 at the South Carolina line near Landrum, SC
Location
Country	United States
State	North Carolina
Counties	Madison, Buncombe, Henderson, Polk
Highway system
Interstate Highway System Main Auxiliary Suffixed Business Future North Carolina Highway System Interstate US State Scenic
← US 25 → NC 27

Interstate 26 (I-26) in North Carolina runs through the western part of the state from the Tennessee border to the South Carolina border, following the Appalachian Mountains. It is part of the larger I-26, a regional Interstate that runs from Kingsport, Tennessee, to Charleston, South Carolina. I-26 is mostly four lanes through North Carolina with few exceptions. Though signed with east–west cardinal directions (because of the even number convention), in North Carolina and Tennessee, the route goes nearly north–south, with the northern direction labeled "West" and vice versa.

Within Madison County, I-26 is officially dedicated/memorialized as the Liston B. Ramsey Freeway on the section that over laps with US Highway 23 (US 23).

I-26's original western terminus was I-40/I-240 in Asheville. Between 2003 and 2005, the road was extended further north into Tennessee. Along the segment from Mars Hill to Asheville, there are future I-26 signs as some parts of the road have not yet been upgraded to Interstate Highway standards.

Route description

I-26 in Polk County looking over Skyuka Mountain

I-26, in concurrency with US 23, enters the state at Sams Gap (elevation 3,760 ft or 1,150 m) from Tennessee. In the first nine miles (14 km), designated as a scenic byway, it features mostly six travel lanes and three runaway truck ramps going eastbound. The freeway is also parallels US 23A, which was the original route before 2006. At exit 13, I-26 ends and Future I-26 begins; US 19 also joins from Burnsville.

At Weaverville, Future I-26 merges with US 25/US 70, coming from Marshall; however, US 25 soon disembarks in Woodfin and continues south along Merrimon Avenue. Future I-26 enters Asheville, while parallel with the French Broad River, and merges with westbound I-240/US 74A with US 19/US 23; US 70 ends its concurrency by going eastbound I-240/US 74A instead and an additional exit at the major interchange provides access to downtown Asheville via Patton Avenue. It is signed I-26 proper again without future designation after merging with I-240, although NCDOT still officially refers to this semgent as Future I-26.

Crossing the French Broad River along Capt. Jeff Bowen Bridge (originally Smokey Park Highway Bridge before 2012), I-26/I-240 promptly exit with two lanes to the right (same for both directions) while US 19/US 23/US 74A continue along Patton Avenue (exit 3). The interchange also features warning lights for "stopped traffic ahead", a common condition during rush hour. Between Patton Avenue (exit 3) and Haywood Road (exit 2), I-26/I-240 share a hidden concurrency with US 19 Business (US 19 Bus.)/US 23 Bus.

At the major interchange with I-40, sometimes called Malfunction Junction, I-240 ends, with new concurrency of I-26 with US 74. The interchange features left exit and entrances; while travelers along eastbound I-26/westbound I-240, access to eastbound I-40 is via North Carolina Highway 191 (NC 191, Brevard Road, exit 1). Westbound I-40/US 74 continues on to Canton and Knoxville; eastbound I-40 provides access to nearby Biltmore Estate and further on to Hickory.

Near milemarker 36, the Blue Ridge Parkway crosses over I-26 with a 75.1-foot (22.9 m) clearance; access to the Blue Ridge Parkway is via NC 191 (exit 33).

In Fletcher, I-26 goes by Asheville Regional Airport and accesses NC 280 to Brevard and Mills River (exit 40); 3.2 miles (5.1 km) later, US 25 rejoins (exit 44). In Hendersonville, it connects with US 64, which connect travelers to nearby Chimney Rock, Lake Lure, and Brevard. Between milemarkers 53 and 54, I-26 crosses the Eastern Continental Divide (elevation 2,130 ft or 650 m) at the County Road 1803 (CR 1803, Crest Road) overpass. Near East Flat Rock, US 25 separates again toward Greenville, South Carolina, while I-26 goes southeasterly down along Dodging Hill and crosses over the Green River along the Peter Guice Memorial Bridge, with a 235-foot (72 m) clearance from the river, making it the highest bridge in North Carolina.

At Howard Gap (elevation around 1,900 ft or 580 m), an additional truck lane is available on westbound I-26 for three miles (4.8 km). In Columbus, US 74 ends concurrency at exit 67, continuing east toward Shelby. At 71.4 miles (114.9 km), which combines I-26 and Future I-26, I-26 crosses the state line and into South Carolina.

Aerial view of Asheville Regional Airport with I-26/US 74 on the right

I-26 also make up part of Corridor B in the Appalachian Development Highway System (ADHS). Corridor B connects I-40, in Asheville with US 23, near Lucasville, Ohio; it overlaps nine miles (14 km) of I-26 and 22 miles (35 km) of Future I-26. The ADHS provides additional funds, as authorized by Congress, which have enabled I-26 to benefit from the successive improvements and widening along its routing within the corridor. The white-on-blue banner "Appalachian Highway" is used to mark the ADHS corridor.

I-26 overlaps with one state scenic byway simply known as the "I-26 Scenic Byway". Located from the Tennessee state line to exit 9 (US 19/US 23A) near Mars Hill. The byway is known for its unspoiled views of the North Carolina Mountains.

History

I-26 appeared in the original Interstate Highway plans running from Charleston to Asheville. The road was first mapped as an under construction highway from US 25 near Hendersonville north to NC 280 (current NC 146). The first segment opened in 1966 beginning at NC 280 to the US 25 connector near East Flat Rock. In 1969, I-26 was extended north to I-40, and the South Carolina segment was extended to NC 108 near Columbus. In 1973, I-26 was extended from the US 25 connector to Saluda. Three years later, I-26 was connected. The segment from Saluda to NC 108 was completed. In late 2003, when the Madison County section opened, the Buncombe County section received the designation "Future I-26" because it did not meet Interstate standards. Starting in 2021, the section north of Asheville is scheduled for upgrades.

Building through Howard Gap

One of the hardest places to build I-26 was in Howard Gap. The work was delayed by numerous landslides along Miller Mountain and Tryon Peak. Special engineering had to be done to continue work on I-26 through the area. The most important part was controlling the soil and water on the mountains and surrounding areas. This was achieved through the installation of miles of underground pipe used to drain water from the road.

Future

In 2013, the North Carolina Department of Transportation (NCDOT) reopened the idea of widening I-26 from I-40, in Asheville, to US 25, near Flat Rock. The project had been planned 10 years earlier but was stopped by legal challenges. In 2015, it qualified and became part of the 2016–2025 State Transportation Improvement Program (STIP) and will cost $396 million to build. Right-of-way acquisition begins in 2018, with construction that was originally set to begin in 2020. Construction began sooner than that in October 2019, although it did not extend to US 25 in Flat Rock; it instead terminated at US 64 in Hendersonville. Part of the project does call for the US 25/US 25 Bus. interchange near Naples to be converted into a diverging diamond interchange. Construction is projected to be completed by 2024 at a cost of $531 million.

The I-26 Connector is a $600–$800 million project to build the missing gap of I-26 through Asheville. Broken into three sections, they are all planned and funded in the 2016–2025 STIP. Section A, between Haywood and Brevard roads, will be a widening project with reconfiguration of ramps at Haywood, Amboy, and Brevard roads. Section B, between north of Haywood Road to US 19/US 23/US 70, is the most expensive section of the project, at $332 million. After a review of various alternative designs, both state and federal agencies choose Alternative 4B, which will convert Patton Avenue along Bowen Bridges to local traffic and reroute I-240 along I-26 further north. Section C, the I-26/I-240/I-40 interchange, will be reconfigured to include missing ramp connects and a widening of I-40 through the area. The approximately seven-mile (11 km) project will begin right-of-way acquisition in 2019, with construction on all three sections in 2021.

Another project, between Broadway Avenue and the US 19/US 23A interchanges, will be upgraded to Interstate standards by replacing bridges, expanding the highway width and adding shoulders. The project, needed so I-26 can fully be labeled along that stretch, is currently in development. The estimated cost was $99 million, with right-of-way acquisition starting in 2020 and construction in 2022. Delays included state money and worries over how neighborhoods would be affected. Contracts are to be awarded in 2023 and 2024 and construction to take three to five years. The estimated cost increased to $1.2 billion in 2023.

Exit list

County	Location	mi	km	Old exit	New exit	Destinations	Notes
Madison	​	0.0	0.0			I-26 west / US 23 north – Johnson City	Continuation into Tennessee; crosses through Sam's Gap
	​	3.4	5.5		3	US 23A south – Wolf Laurel
	​	9.0	14.5		9	US 19 north / US 23A north – Burnsville, Spruce Pine	North end of US 19 overlap
	Mars Hill	10.9	17.5		11	NC 213 – Mars Hill, Marshall
Buncombe	​	13.2	21.2		13	Forks of Ivy
	​			Route transition from I-26 to Future I-26
	Flat Creek				15	NC 197 – Jupiter, Barnardsville	Existing interchanges of US 19/US 23 (upgrade to interstate standards, funded)
	Stocksville				17	Flat Creek
	Weaverville				18	US 19 Bus. south / Monticello Road – Weaverville
					19	US 25 north / US 70 west – Marshall, Weaverville
					21	New Stock Road – Weaverville
	Woodfin				23	US 25 south / US 19 Bus. north (Merrimon Avenue) – Woodfin, North Asheville
					24	Elk Mountain Road  Woodfin
	Asheville				25	NC 251 – UNC Asheville
						Hill Street
						I-240 / US 70 / US 74A east / Patton Avenue	Existing interchanges of I-240 (realign and upgrade to interstate standards, funded)
					3B	Westgate / Resort Drive
					3A	US 19 / US 23 south / US 74A west (Patton Avenue) US 19 Bus. / US 23 Bus. begin
					2	US 19 Bus. / US 23 Bus. south (Haywood Street) – West Asheville
					1C	Amboy Road
					1B	NC 191 (Brevard Road) to I-40
				Route transition from Future I-26 to I-26
		31.4	50.5	1B	31B	I-40 west / US 74 west – Canton, Knoxville	West end of I-240 / US 74 overlap
		31.9	51.3	1A	31A	I-40 east – Hickory, Biltmore Estate	Westbound exit and eastbound entrance
		33.0	53.1	2	33	NC 191 / Blue Ridge Parkway	To Asheville Outlets
	​				35	Frederick Law Olmsted Way East	New interchange to be under construction in Spring 2023; left hand exit and entrance ramps northbound
	​	37.7	60.7	6	37	NC 146 / Long Shoals Road – Skyland
	Arden	40.8	65.7	9	40	NC 280 – Asheville Regional Airport, Arden, Brevard	To WNC Agriculture Center
Henderson	Fletcher	44.1	71.0	13	44	US 25 north / US 25 Bus. south – Fletcher, Mountain Home	North end of US 25 overlap
	Hendersonville	49.9	80.3	18	49	US 64 – Hendersonville, Bat Cave	Signed as exits 49A (east) and 49B (west)
		53.4	85.9	22	53	Upward Road – Hendersonville
	​	54.4	87.5	23	54	US 25 south to US 176 / NC 225 – Greenville	South end of US 25 overlap; to Carl Sandburg Home and Flat Rock Playhouse
	Green River	56.5	90.9	Peter Guice Memorial Bridge
Polk	Saluda	59.6	95.9	28	59	Saluda
	Columbus	66.6	107.2		66	US 74 east – Forest City, Shelby	Westbound exit
		67.1	108.0	36	67	US 74 east / NC 108 – Columbus, Rutherfordton, Tryon	East end of US 74 overlap
	​	71.4	114.9			I-26 east – Spartanburg	Continuation into South Carolina
1.000 mi = 1.609 km; 1.000 km = 0.621 mi       Concurrency terminus       Incomplete access       Route transition       Unopened

See also

• Biltmore Estate
• French Broad River
• Pisgah National Forest

External links

• Media related to Interstate 26 in North Carolina at Wikimedia Commons